Good afternoon, members of the forum.
My previous post about extraneous noises when Wifi is on was deleted, so I am doing a new one with a small manual for solving the problem.
The treatment procedure is very simple, you need to take a couple of steps.
1. Open the front cover.
2. Gently pull on the black wire that goes from the lower right corner below the lens.
3. The top of the antenna Wifi will take out.
4. Secure it with scotch tape on the front side of the board, the lower from the wires that go to the microphone, the better.
My previous post about extraneous noises when Wifi is on was deleted, so I am doing a new one with a small manual for solving the problem.
The treatment procedure is very simple, you need to take a couple of steps.
1. Open the front cover.
2. Gently pull on the black wire that goes from the lower right corner below the lens.
3. The top of the antenna Wifi will take out.
4. Secure it with scotch tape on the front side of the board, the lower from the wires that go to the microphone, the better.
