Recent content by SP777

@viofo , bloo890 is right. The request was about a more general case than just "the camera is not recording". Please take a moment to respond to the original message.

@viofo Any reaction on this feature request?

Bitrate: high - for higher vidfeo quality (also uses more space on your microSD card) Loop Recording: 5 Min - totally subjective choice WDR: off - I'll do more experimenting with on/off in different weather/lighting conditions Parking Mode: 3fps - captures enough information, but keeps space...

@viofo your reply would be much appreciated

It would be quite problematic, if not impossible, to pull such a cable through rubber sleeves connecting the car's rear gate to the main body.

Yes, it is by design. ACC input is used only as a signal, all the power is always taken from the Battery input.

Hi travellerr. Having WiFi always on will reduce video bitrate = quality, even if no WiFi devices are connected. If it's ok with you, you can keep WiFi always on.

This is an overkill, as formatting destroys all the recorded footage. In this case one need to be fully sure that there is nothing useful recorded even most recently, which may be quite challenging. So a non-destructive approach (as proposed above) would be more appropriate. On the other hand...

A dashcam is a kind of insurance in case of some unwanted incident. To be useful, it should guarantee that all the action is captured and reliably preserved. It’s not a secret that microSD cards are subject to wearing out under a high load as in case of use in dashcams. Therefore write and read...