speed_Freakz
New Member
- Joined
- Nov 2, 2021
- Messages
- 6
- Points
- 1
I bought Viofo 139 3ch camera with hardwire cable.
I own 2012 Mazda 2 sport.
The problem is I don't have a single fuse that is constantly on, I checked with a multimeter and not a single one. Now I don't want to go under the hood through the firewall, but I still want to do hardwiring cause I don't want cables dangling around the car while using a lighter plug.
However, I connected the yellow wire to the fuse that gets power when the car is switched on (cause that's the only fuses that I can use inside) and I connected the ground wire, but the camera doesn't turn on. Is this how it should be? basically, can the camera turn on if the red wire isn't connected anywhere?
Now, if I connect the red wire to another fuse, the camera switches on when the ignition is started. At one forum I read that in case of not using parking mode, that both red and yellow wires should be connected to the same fuse, is this true?
I own 2012 Mazda 2 sport.
The problem is I don't have a single fuse that is constantly on, I checked with a multimeter and not a single one. Now I don't want to go under the hood through the firewall, but I still want to do hardwiring cause I don't want cables dangling around the car while using a lighter plug.
However, I connected the yellow wire to the fuse that gets power when the car is switched on (cause that's the only fuses that I can use inside) and I connected the ground wire, but the camera doesn't turn on. Is this how it should be? basically, can the camera turn on if the red wire isn't connected anywhere?
Now, if I connect the red wire to another fuse, the camera switches on when the ignition is started. At one forum I read that in case of not using parking mode, that both red and yellow wires should be connected to the same fuse, is this true?