Power consumption, Menu Button and 2 Wire Kit

[ralph62]

Hi,

first, the Power consumption of the Cams was around 300mA when it run in Parking Mode. Thats not less. For a small battery a a long weekend, this can be a Problem.

Second, my Menu dont open when I press the Button, sometimes Pics would be made, when I press the Button long, Power off

Last, I use a 2 wire Kit, works this too (permanent 12V) or it must be the 3 Wire Kit?

Thx

 

[VIOFO-Swin]

1. If use 2 wire hardwire kit in parking mode, it will cut off the power supply while the battery voltage is around 11.6V ~ 11.8V, to protect your car battery.
2. When recording, please press "REC" to stop recording first and then press "Menu" button to enter into menu setting.
3. It supports 2 wire kit too, but without ACC detection, so the camera will switch to parking mode recording after 5 minutes if no motion detected and no G-sensor impact.

 

[ralph62]

Thank you for this Information.

I have orderd the 3-wire kit, after installation I will check out the power consumption again.