Hello. New to the A129 Duo, but not new to DashCams. Have used several over the years. I've installed the A129 Duo hard wired with ACC and Battery fuse terminals. Unit functions fine until it sits overnight. Record light and mic light will be on, but the unit does not respond or record. I have to unplug the unit and wait for a couple of minutes for the lights to finally turn off, then it will power back on and function fine until it sits overnight again. I have tried with Park mode on and off. I currently have it off.
I double check the wiring and it is correct. Battery terminal is hot all the time and ACC terminal is on with ignition. Ground is good.
The unit is plugged in to the GPS mount. Should it be?
I returned another unit due to this, and this is the replacement. So obviously there is some issue that I don't understand, or I received two defective units.
The firmware is latest version according to the iPhone App. I do not keep WiFi on as I noticed this too causes the unit to act up.
I'm using SanDisk 256GB High Endurance Video card and have swapped these to make sure it wasn't a card issue.
I welcome input and ideas. I really want to like this unit for the features and cost, but reliability seems to be an issue.
I double check the wiring and it is correct. Battery terminal is hot all the time and ACC terminal is on with ignition. Ground is good.
The unit is plugged in to the GPS mount. Should it be?
I returned another unit due to this, and this is the replacement. So obviously there is some issue that I don't understand, or I received two defective units.
The firmware is latest version according to the iPhone App. I do not keep WiFi on as I noticed this too causes the unit to act up.
I'm using SanDisk 256GB High Endurance Video card and have swapped these to make sure it wasn't a card issue.
I welcome input and ideas. I really want to like this unit for the features and cost, but reliability seems to be an issue.